Kollmorgen MMC-SD-1.0-230 晶体管控制器

作为科尔摩根，伺服产品系列的成员。是科尔摩根经验丰富的工程师集成七十余年电机设计和制造经验，结合新的电磁设计理念，全力打造更小体积、更大出力的新一代伺服电机产品，代表了高新能伺服电机领域的全新水准。

The  is a member of the Kollmorgen  servo product family. It is the result of Kollmorgen's experienced engineers integrating more than seventy years of motor design and manufacturing experience with new electromagnetic design concepts to create a new generation of servo motors that are smaller in size and higher in output.It represents a new standard in the field of high-performance servo motors.

模块背板从后面连接到19"模块中。晶体管控制器插入模块并插入背板，电信号通过端子、螺柱和平针连接器在背面板上提供。

The  -module backplane connects into the 19" module from the rear. The transistor controller is inserted into the module and plugged into the backplane, and electrical signals are provided on the backplane via terminals, studs and flat pin connectors.

避免烧坏触点,甚至毁坏控制器中的整个电路模块,以及避免充满电的电容器造成人危险至关重要。电容器中的残余电荷在超过120秒后，仍可能达到危险水平。关闭主电源后，仅当电压低于最小阈值水平时才连接或断开控制器。电源电压关闭后，观察控制器中的LED。短时间后，绿色LED 将熄灭，红色LED 将短暂亮起，现在您可以拔出或插入控制器。

 It is essential to avoid burning out contacts or even destroying the entire circuit module in the controller, as well as avoiding the danger to people posed by a fully charged capacitor. The residual charge in the capacitors may still reach dangerous levels after more than 120 seconds. After switching off the mains supply, connect or disconnect the controller only when the voltage is below the minimum threshold level. After the mains voltage has been switched off, observe the LEDs in the controller. after a short period of time the green LED will go out, the red LED will light up briefly and you can now unplug or plug in the controller.