Kollmorgen MMC-SD-1.0-230-D 晶体管控制器

模块背板从后面连接到19"模块中。晶体管控制器插入模块并插入背板，电信号通过端子、螺柱和平针连接器在背面板上提供。

The  -module backplane connects into the 19" module from the rear. The transistor controller is inserted into the module and plugged into the backplane, and electrical signals are provided on the backplane via terminals, studs and flat pin connectors.

避免烧坏触点,甚至毁坏控制器中的整个电路模块,以及避免充满电的电容器造成人危险至关重要。电容器中的残余电荷在超过120秒后，仍可能达到危险水平。关闭主电源后，仅当电压低于最小阈值水平时才连接或断开控制器。电源电压关闭后，观察控制器中的LED。短时间后，绿色LED 将熄灭，红色LED 将短暂亮起，现在您可以拔出或插入控制器。

It is essential to avoid burning out contacts or even destroying the entire circuit module in the controller, as well as avoiding the danger to people posed by a fully charged capacitor. The residual charge in the capacitors may still reach dangerous levels after more than 120 seconds. After switching off the mains supply, connect or disconnect the controller only when the voltage is below the minimum threshold level. After the mains voltage has been switched off, observe the LEDs in the controller. after a short period of time the green LED will go out, the red LED will light up briefly and you can now unplug or plug in the controller.

对客户的一个关键优势是可以将现有设计中的电机替换成，在提升机器性能的同时，不增加机器尺寸。而对于新机器的设计，为客户提供与现有解决方案相比，更小的机器尺寸和占地面积的能力。

A key advantage of  for customers is the ability to replace motors in existing designs with , improving machine performance without increasing machine size. And for new machine designs, providing customers with the ability to reduce machine size and footprint compared to existing solutions.